Installing the speakers for mainstream
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Figure 34. Installing the speakers for mainstream
Steps
1. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
NOTE:
If the rubber grommets are pushed out during speaker removal, make sure to reinsert them before reinstalling
the speakers.
2. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the connector on the I/O daughterboard.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
Before working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
63