Installing The Edp Cable - Dell Latitude 5430 Service Handbook

2. Peel the conductive tape and unroute the eDP cable to release it from adhesive and lift the eDP cable from the display back
cover.

Installing the eDP cable

Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
About this task
The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
Steps
1. Connect the eDP cable to the connector on the camera.
2. Adhere the eDP cable to the display back cover.
3. Adhere the conductive tape and route the eDP cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the WWAN card.
Ta bort och installera komponenter 75