Installing The Heat-Sink Assembly - Dell Latitude 5430 Service Handbook

Steps
1. Disconnect the system fan cable from the connector on the system board.
2. Remove the two (M2x5) screws that secures the system fan and heat-sink assembly to the system board.
3. Loosen the four captive screws that secure the heat-sink assembly to the system board.
4. Lift the heat-sink assembly off the system board.

Installing the heat-sink assembly

Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
About this task
The following image indicates the location of the heat-sink assembly and provides a visual representation of the installation
procedure.
Ta bort och installera komponenter 41