Steps
1. Align and place the battery from the left side on the computer.
2. Replace the three (M2x5) screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to the system board.
Next steps
1. Install the
base
cover.
2. Install the
microSIM
card.
3. Install the
microSD
card.
4. Follow the procedure in
Batterikabel
Removing the battery cable
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
microSIM
4. Remove the
base
cover.
5. Remove the
3-cell battery
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
after working inside your
before working inside your
card.
card.
or
4-cell
battery.
computer.
computer.
Ta bort och installera komponenter
33