Kylfläns; Removing The Heat-Sink Assembly - Dell Latitude 5430 Service Handbook

Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the (M2x3) screw to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the system board.
Next steps
1. Install the 3-cell battery
2. Install the base cover.
3. Install the microSIM card.
4. Install the microSD card.
5. Follow the procedure in
Kylfläns

Removing the heat-sink assembly

Prerequisites
1. Follow the procedure in
CAUTION: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
2. Remove the microSD
3. Remove the microSIM
4. Remove the base cover.
5. Remove the 3-cell battery
About this task
The following image indicates the location of the heat-sink assembly and provides a visual representation of the removal
procedure.
40 Ta bort och installera komponenter
or 4-cell battery.
after working inside your
before working inside your
card.
card.
or 4-cell battery.
computer.
computer.