Wiring Requirements - Majestic Quartz Series Installation Manual

B. Wiring Requirements
IntelliFire Touch Ignition System Wiring
®
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.3, IntelliFire Touch (IPI) Wiring Diagram.
• This appliance is equipped with an IntelliFire control valve
which operates on a 6 volt system.
• Plug the 6 volt transformer plug into the appliance junction
box to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
IFT-RC400
REMOTE
CONTROL
IFT-RC150
WIRELESS
WALL SWITCH
(OPTIONAL)
RF MODULE
ORANGE
(PILOT)
Figure 8.3 IntelliFire Touch Wiring Diagram
Majestic • QUARTZPLA36IN / QUARTZPLA36IL Installation Manual • 2643-980 Rev. B • 7/22
52
TO JUNCTION
BOX (110-120 VAC)
FLAME
IGNITER
SENSE
WHITE ORANGE
AUXILIARY CONTROL
ELECTRONIC CONTROL
MODULE (ACM)
MODULE (ECM)
FLAME
MODULATION
GREEN
(MAIN)
RED
BLK (GROUND)
APPLIANCE
BLK
BRN
ON/OFF
CONTROL
(OPTIONAL)
NOTICE: Batteries should only be used as a power
source in the event of an emergency power outage.
Batteries should not be used as a primary long-term power
source. Batteries tend to corrode over time. When using
batteries as a power source, the 6 volt transformer must
be unplugged from the receptacle.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service.
LED's
LED's are factory installed.
maintenance is required.
TO JUNCTION
BOX (110-120 VAC)
FAN
LED
CONTROL
NOT USED FOR QUARTZPLA36IN / QUARTZPLA36IL MODELS
6V DC
MODELS.
BATTERY PACK
RED
BLK
No additional set up or
(OPTIONAL POWER VENT)
PVLP-SLP
PVI-SLP-B
PVV-SLP
WIRE HARNESS
PVI-WH10
PVI-WH20
PVI-WH40
PVI-WH60
PVI-WH80
PVI-WH100
EMBER LIGHTING