Leds - Cisco NPE-175 Installation And Configuration Manual

Chapter 6 NPE-G2 Overview
•
Figure 6-2
1
2
3
4
5
6
7
The Fast Ethernet Management RJ-45 port is only used for management activities—not for any other
Note
purpose.
The USB function is not supported on Cisco uBR7200 series routers.
Note

LEDs

This section provides information about the location and behavior of the NPE-G2 LEDs.
The NPE-G2 faceplate contains LEDs that indicate system and port status. The RJ-45 and SFP ports
share the same LINK ACTV LED because only one of these ports per interface (0/1, 0/2, or 0/3) can be
used at any one time. The EN (Enable) LED is on if the RJ-45 port is in use.
The PWR OK LED is on whether or not an I/O controller is present in the router. The CompactFlash
Disk slot can be used whether or not an I/O controller is present in the router. The SYST STAT LED
provides information about the status of the system.
OL-4448-12
The port numbering for the interfaces on the NPE-G2 starts with 0/1 and not with 0/0, as is typical
for other interface cards. This is to avoid conflicts with the Ethernet and Fast Ethernet ports on an
I/O controller, if it is also installed.
NPE-G2 Interfaces
2 4
GIGABIT ETHERNET 0 / 1 GIGABIT ETHERNET 0 / 2
LINK LINK
ACTV ACTV
NPE-G2
CPU
EN EN
RESET
RJ45 RJ45
1 3
CPU Reset
Fast Ethernet/Gigabit Ethernet RJ-45 port—GE 0/1
Gigabit Ethernet port—GE 0/1
Fast Ethernet/Gigabit Ethernet RJ-45 port—GE 0/2
Gigabit Ethernet port—GE 0/2
Fast Ethernet/Gigabit Ethernet RJ-45 port—GE 0/3
Gigabit Ethernet port—GE 0/3
Network Processing Engine and Network Services Engine Installation and Configuration
6 8
GIGABIT ETHERNET 0 / 2
LINK
ACTV
EN
RJ45 CONSOLE
5 7
NPE-G2 Description and Overview
10 11 13
NETWORK PROCESSING ENGINE - G2
FE
COMPACT FLASH
LINK
U
S
B
CF
ACTV
USB
AUX FE 0/2
FOR MANAGEMENT
USE ONLY
9 12
8
Console port
9
Auxiliary port
10 Fast Ethernet Management
port—FE 0/2
11 USB port 0
12 USB port 1
13 CompactFlash Disk slot
SYST
STAT
PWR
OK
6-5