Removing and Replacing the NPE or NSE
Warning
Read the installation instructions before you connect the system to its power source. Statement 10
Note
When installing an NPE-175, NPE-225, NPE-300, NPE-400, or NSE-1 in a Cisco 7200 VXR router that
is using a previously purchased I/O controller, you must upgrade the I/O controller boot helper image.
Instructions for upgrading the boot helper image on the I/O controller are contained in the online
Memory Replacement Instructions for the Network Processing Engine or Network Services Engine and
Input/Output Controller
To reconnect AC-input power or DC-input power to a Cisco 7200 series router, Cisco 7200 VXR router,
or Cisco uBR7200 series router, see these sections:
Reconnecting AC-Input Power to the Cisco 7200 Series Router or Cisco 7200 VXR Router,
•
page 9-25
Reconnecting AC-Input Power to the Cisco uBR7200 Series Router, page 9-26
•
Reconnecting DC-Input Power to a Cisco 7200 Series Router or Cisco 7200 VXR Router, page 9-27
•
Reconnecting DC-Input Power to a Cisco uBR7246VXR Router, page 9-29
•
Powering Up the Router, page 9-33
•
Network Processing Engine and Network Services Engine Installation and Configuration
9-24
publication.
Chapter 9
Removing and Installing the NPE or NSE
OL-4448-12