Copying The Saved Configuration File From A Flash Disk Or Pc Card; Copying The Saved Configuration File From The Compactflash Disk - Cisco NPE-175 Installation And Configuration Manual

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Copying the Saved Configuration File from a Flash Disk or PC Card

To copy the saved configuration file from the Flash Disk or PC Card, follow these steps:
Step 1 Make sure you are at the privileged level of the EXEC command interpreter (check the system prompt
for a pound sign [#]). If the system prompt does not have a pound sign (#), enter enable, and then your
password.
Insert the Flash Disk or PC Card containing the saved configuration file into the first PC Card slot in
Step 2
the I/O controller.
Enter the copy disk0: filename running or copy slot0: filename running command.
Step 3
Router# copy disk0:filename running
or
Router# copy slot0:filename running
Enter the write command:
Step 4
Router# write
You have finished copying and writing the saved configuration file to NVRAM.

Copying the Saved Configuration File from the CompactFlash Disk

If you have been able to copy the configuration file to the CompactFlash Disk, use the following steps
to copy the configuration to the NVRAM on the NPE-G1 or NPE-G2:
Make sure you are at the privileged level of the EXEC command interpreter (check the system prompt
Step 1
for a pound sign [#]). If the system prompt does not have a pound sign (#), enter enable, and then your
password.
Insert the CompactFlash Disk containing the saved configuration file into the CompactFlash Disk slot
Step 2
on the NPE-G1 or NPE-G2.
Enter the copy disk2: filename command.
Step 3
Router# copy disk2:filename running
Enter the write command:
Step 4
Router#: write
You have finished copying and writing the saved configuration file to NVRAM.
OL-4448-12
Network Processing Engine and Network Services Engine Installation and Configuration
Copying the Saved Configuration to NVRAM
7-53