Reconnecting Ac-Input Power To The Cisco Ubr7225Vxr Router; Reconnecting Dc-Input Power To The Cisco 7200 Vxr Router - Cisco NPE-175 Installation And Configuration Manual

Installing the NPE-G1 or NPE-G2

Reconnecting AC-Input Power to the Cisco uBR7225VXR Router

To connect AC-input power to the Cisco uBR7225VXR router, complete the following steps:
At the rear of the router, ensure that the power switch on the power supply is in the off position.
Step 1
Figure 7-26
4
1
2
Plug the power cable into the AC connector of the power supply.
Step 2
For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a
Note
nylon cable tie through the hole in the handle and around the cable.
Plug the AC power supply cable into the AC power source.
Step 3
Step 4 Repeat
Step 5 Turn on the power switch on the router.
This completes the steps for reconnecting AC-Input power to a Cisco UBR7225VXR router. Proceed to
the

Reconnecting DC-Input Power to the Cisco 7200 VXR Router

To reconnect DC-input power to a Cisco 7200 VXR router, complete the following steps.
Note The color coding of the DC-input power supply leads depends on the color coding of the DC power
source at your site. Typically, green or green and yellow are used for ground. Make certain that the lead
color coding you choose for the DC-input power supply matches the lead color coding used at the DC
power source.
Network Processing Engine and Network Services Engine Installation and Configuration
7-38
Connecting AC-Input Power to a Cisco UBR7225VXR Router
1
3
Power switch
Handle
Step 1 through Step 3 for the second power supply, if required.
"Powering Up the Router" section on page 7-45
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
2
4 AC-input receptacle
5 Captive installation screw
uBR7225-VXR
uBR7225-VXR
OL-4448-12