Disconnecting Ac-Input Power From A Cisco Ubr7200 Series Router - Cisco NPE-175 Installation And Configuration Manual

Removing and Replacing the NPE or NSE
Disconnecting AC-Input Power from a Cisco 7200 Series Router or Cisco 7200 VXR Router
To disconnect AC-input power from a Cisco 7200 series router or Cisco 7200 VXR router, complete the
following steps:
Unplug the input power cable from the power source.
Step 1
Push up on the cable-retention clip that secures the input power cable to the router power supply.
Step 2
Unplug the other end of the input power cable from the power supply. See
Step 3
Figure 9-1
1
2
Repeat Step 1 through Step 3 if a second power supply is installed.
Step 4
This completes the procedure for disconnecting AC-input power from a Cisco 7200 series router or
Cisco 7200 VXR router. Go to the

Disconnecting AC-Input Power from a Cisco uBR7200 Series Router

To disconnect AC-input power from a Cisco uBR7200 series router, complete the following steps:
Step 1 Unplug the input power cable from the power source.
Push the cable-retention clip that secures the input power cable to the router power supply to the left.
Step 2
Unplug the other end of the input power cable from the power supply. See
Step 3
Network Processing Engine and Network Services Engine Installation and Configuration
9-4
Disconnecting Power from a Cisco 7200 Series AC-Input Power Supply
AC-input receptacle
Internal fans
Chapter 9
1
NETWORK PROCESSING ENGINE-300
3 4
3
Power switch
4
AC-input power supply
"Removing the NPE or NSE" section on page
Removing and Installing the NPE or NSE
Figure 9-1.
2
9-9.
Figure 9-2.
OL-4448-12