Using The Show Mpf Interface Command - Cisco NPE-175 Installation And Configuration Manual

Enabling the Second Processor on the NPE-G1

Using the show mpf interface Command

Using the show mpf interface command without arguments shows the interface information for all
Gigabit Ethernet interfaces and subinterfaces. This command is supported only for physical interfaces.
There is no support for the virtual access interface.
Router# show mpf interface
Name
Gi0/1
Gi0/1
Gi0/1.100
Gi0/1.101
Gi0/1.102
Gi0/1.105
Gi0/1.106
Gi0/1.107
Gi0/1.200
Gi0/1.201
Gi0/1.202
Gi0/1.206
Gi0/1.2002 602
Gi0/1.2004 604
Using the show mpf interface GigabitEthernet 0/1 Command
The following example displays the interface information for GigabitEthernet 1/0, subinterface number
100. However, all Gigabit Ethernet interface and subinterface information is displayed because MPF
does not recognize the subinterface number, unless it is a VLAN number.
Router# show mpf interface GigabitEthernet 0/1.100
Name
Gi0/1
Gi0/1
Gi0/1.100
Gi0/1.101
Gi0/1.102
Gi0/1.105
Gi0/1.106
Gi0/1.107
Gi0/1.200
Network Processing Engine and Network Services Engine Installation and Configuration
7-50
CPU% per hour (last 72 hours)
* = maximum CPU% # = average CPU%
Index State Counter
0 up RX packets
RX bytes
TX packets
TX bytes
RX punts
TX punts
1 up
100 up RX packets
RX bytes
TX packets
TX bytes
RX punts
101 up
102 up
105 up
106 up
107 up
200 up
201 up RX punts
202 up
206 up
up RX punts
up
Index State Counter
0 up RX packets
RX bytes
TX packets
TX bytes
RX punts
TX punts
1 up
100 up RX packets
RX bytes
TX packets
TX bytes
RX punts
101 up
102 up
105 up
106 up
107 up
200 up
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Count
1004
158632
5004
790632
32961
85972
1004
158632
5004
790632
25
29
26114
Count
1004
158632
5004
790632
32996
86062
1004
158632
5004
790632
25
OL-4448-12