Table of Contents
Advertisement
48
en | wLSN Devices
Callout
1
2
3
5.
6.
7.
8.
9.
10. Test the detector's sensitivity.
F01U138553 | 01 | 2010.05
Description
Smoke chamber base
Optical chamber
Alignment arrows
Use compressed air or a soft-bristled brush to remove dust
and dirt from the smoke chamber base.
Align the new optical chamber with the base and snap into
place.
To attach the detector cap, align the cap with the detector,
press the cap onto the detector, and turn the cap
clockwise to snap it firmly into place.
Observing the proper polarity, install the batteries and the
battery cover. If the batteries are not installed, the
detector does not fit properly onto the mounting base.
Mount the detector onto the mounting base.
Refer to Section Sensitivity Test, page 45.
System Reference Guide
Bosch Security Systems, Inc.
wLSN
Advertisement
Table of Contents
