Table of Contents
Advertisement
16
en | Discovering and Defaulting a wLSN Device
Figure 4.5 Transmitter PCB and Jumper Pins
Callout
1
2
3
4
5
6.
7.
8.
9.
F01U138553 | 01 | 2010.05
1
Description
Housing base
Transmitter PCB
Jumper plug in normal operating position
(plug covers a single pin)
Jumper plug removed from pin
Jumper plug covering both pins
Reinsert the batteries. Do not close the housing base. The
detector is now defaulted.
Remove the jumper and replace it over one pin (normal
operating position).
Replace the housing cover on the housing base. Align the
sounder with the notch on the housing cover and push
firmly until the cover and base snap into place.
Close the battery case and mount the detector onto its
mounting base.
System Reference Guide
2
3
4
Bosch Security Systems, Inc.
wLSN
5
Advertisement
Table of Contents
