Table of Contents
Advertisement
wLSN
Adjusting the Microwave Range in Dual Motion Detectors
NOTICE!
The microwave sensor in the dual motion detectors is adjusted
in the factory to sense motion to a minimum of 11 m (35 ft).
If the detector's red or yellow LED does not light, the
microwave coverage requires adjustment:
1.
2.
3.
Figure 5.4 Adjusting the Dual Motion Detector's Microwage Range
Bosch Security Systems, Inc.
Turn the potentiometer as shown in Figure 5.4 to increase
or decrease the coverage.
Repeat the walk test.
Refer to Section 5.3.2 Walk Test, page 24.
Repeat Steps 1 and 2 until the required coverage is met.
System Reference Guide
_
+
wLSN Devices | en
F01U138553 | 01 | 2010.05
23
Advertisement
Table of Contents
