Advertisement
4
Check the message, then press [OK].
The settings of the cross-point pad on the selected
switcher bank/AUX bus control block are returned to
the defaults.
Copying cross-point pad settings
You can copy the settings of the cross-point pad in the
cross-point control block or AUX bus control block.
The following settings are copied between cross-point
pad pages.
• Button assignments
• Page recall function settings
• Page name
When all pages are selected as the target for copying, the
following settings are copied.
• Button assignments
• Page recall function settings
• Page names
• Home page setting
• Display mode setting (see page 404)
• Utility bus mode setting (cross-point control block
only) (see page 405)
Note
Cross-point pad settings cannot be copied between a
cross-point control block and an AUX bus control block.
1
Open the Home > Setup > Panel > Xpt Module > Xpt
Pad Copy menu (19104.37).
2
Press the [Bank] button on the left side and select the
copy source switcher bank/AUX bus control block
(AUX 1, AUX 2) from the pull-down list.
3
Press the [Page] button on the left side and select a
copy source cross-point pad page number from the
pull-down list.
To copy all pages, select [All Pages].
The button image for the selected page is displayed in
[Button Assign] on the left side.
Note
When [All Pages] is selected, the button image is not
displayed.
4
Press the [Bank] button on the right side and select
the copy destination switcher bank/AUX bus control
block (AUX 1, AUX 2) from the pull-down list.
5
Press the [Page] button on the right side and select a
copy destination cross-point pad page number from
the pull-down list.
The button image for the selected page is displayed in
[Button Assign] on the right side.
Notes
• When [All Pages] is selected using the [Page]
button on the left side, [All Pages] is automatically
selected for the [Page] button on the right side. If
the [Page] button selection is changed to a page
number on either side, the [Page] button selection
on the other side is also changed to page number.
• When [All Pages] is selected, the button image is
not displayed.
6
Press the [Copy] button.
When [All Pages] is selected
Check the message, then press [OK] to execute the
copy.
To execute a copy using button operation
When copying all pages, you can execute the copy using
button operation on the control panel.
To copy the cross-point pad settings, press and hold the
[XPTPAD COPY] button on the copy source cross-point
pad and press the [XPTPAD COPY] button on the copy
destination cross-point pad.
408
Advertisement
Chapters
