Advertisement
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Auto Trans/Take] group, select an operation
mode.
Continue: Continue the transition.
Cancel: Cancel the transition and return to the
previous state before executing the transition.
ICP-X1000 series configuration
Note
Enabled using the [AUTO TRANS] button and a [KEY1
TRANS] to [KEY8 TRANS] button in the transition
control block.
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Auto Trans] group, select an operation mode.
Continue: Continue the transition.
Cancel: Cancel the transition and return to the
previous state before executing the transition.
Setting the next transitions to select
using the [ALL] button in the transition
control block
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Next Trans All] group, select a button to
include for the next transition.
You can select multiple buttons.
Bkgd: [BKGD] button
Key Priority: [KEY PRIOR] button
Key1 to Key8: [KEY1] button to [KEY8] button
Enabling double-press for the [BKGD]
button in the transition control block
When double-press is enabled, pressing the [BKGD]
button twice in quick succession selects all currently
inserted keys and removes them in the next transition.
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Bkgd Trans Btn Double Click] group, select
whether to enable/disable the double-press function.
Disable: Disable button double-press.
Enable: Enable button double-press.
Setting the operation mode of the [TRANS
PVW] button in the transition control
block
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Trans PVW] group, select an operation mode.
Hold: Enables transition preview mode only while
the [TRANS PVW] button is pressed.
Lock: Pressing the [TRANS PVW] button switches
between setting and releasing transition preview
mode each time the button is pressed.
Swapping the [AUTO TRANS] button and
[CUT] button in the transition control
block
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
Press the [Auto Trans/Cut Swap] button.
On: Swap the [AUTO TRANS] button and [CUT]
button.
Off: Do not swap the [AUTO TRANS] button and
[CUT] button.
Setting the transition indicator display in
non-sync state
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
2
In the [Non Sync Fader Indicator] group, select a
display mode.
Normal: The transition indicator is lit when in non-
sync state.
Blink: The transition indicator blinks when in non-
sync state.
Setting the main fader lever when using
split faders
When using the fader lever in the simple-type transition
control block as split faders, you can set which is the main
fader lever (right or left). The main fader lever controls
the background A bus.
If the conditions for using split faders are not satisfied,
only the main fader lever can be operated.
1
Open the Home > Setup > Panel > Custom >
Operation Mode menu (19104.61).
413
Advertisement
Chapters
