Advertisement
Entering and Displaying
Text/Numbers
Press a numeric keypad input button to display the
numeric keypad window and enter a numeric value.
For details, see "Numeric Keypad Window" (page 65).
Press a keyboard input button and enter alphanumeric
characters using a computer keyboard/on-screen
keyboard/touch panel.
Invalid characters for names
The following characters cannot be used for entering
names.
\
/
:
*
?
"
Note
When entering names shown on control panel buttons and
the display, "|" is used as a line break code.
Name settings when multiple items are
selected
When setting a name with multiple items selected, the
same name may be set or a consecutive number may be
appended to the name depending on the menu.
In the following menus, a consecutive number is
appended to the name.
• Home > Setup > System > Input > Input Adjust menu
(19101.31)
• Home > Setup > Xpt Assign > Src Name/Src Color >
Edit Src Name/Color menu (19102.51)
• Home > Setup > Panel > Module > Utility Function
Assign menu (19104.22)
Example:
Setting the source name of signals
If three signals are selected as the target and you enter
"CAM", the name of each signal will become "CAM1",
"CAM2", and "CAM3".
Timecode input and frame number input
When entering a timecode, you can select either timecode
input mode or frame number input mode.
Timecode input mode
Press [TC] in the numeric keypad window, turning it on,
to select timecode input mode.
Enter a value in "hh:mm:ss:ff"
(hour:minute:second:frame) format. The ":" (colon) is
inserted automatically.
<
>
|
Example:
To set 3 minutes, 7 seconds, and 15 frames, enter
"30715".
Frame number input mode
When [TC] in the numeric keypad window is turned off,
frame number input mode is selected.
Enter a value in "fff" (frame) format.
Entering a difference from a current value
You can enter a value representing the increase or
decrease from a currently set value to change the setting
value.
[Trim] in the numeric keypad window is used to enter a
difference value.
Enter a positive value and press [Trim] to increase the
setting value.
Enter a negative value and press [Trim] to decrease the
setting value.
Abbreviated display of long names
When a file name is too long to be displayed in full on a
button or in a list, "..." is appended to the name.
Maximum number of valid input
characters
The maximum number of characters described in this
document is the maximum number when using ASCII
characters only.
If characters other than ASCII characters are used, the
maximum number of characters that can be entered is
reduced.
77
Advertisement
Chapters
