Advertisement
Using two to four DME channels on a
single key
You can select multiple consecutive DME channels.
1
Press the [M/E-1] button, turning it on.
2
Press the [KEY1] button, turning it on.
3
Select a DME channel to assign using the DME
channel selection buttons (DME 1 to DME 4).
When using two DME channels
Press the [DME1] button and [DME2] button, the
[DME2] button and [DME3] button, or the [DME3]
button and [DME4] button, turning them on.
When using three DME channels
Press the [DME1] button, [DME2] button, and
[DME3] button, or the [DME2] button, [DME3]
button, and [DME4] button, turning them on.
When using four DME channels
Press the [DME1] button, [DME2] button, [DME3]
button, and [DME4] button, turning them on.
Selecting a DME channel signal
Select the following signals on the 1st channel to 4th
channel.
For details about selecting a signal, see "Chapter 4
Selecting Signals" (page 80).
1st channel signal: Key bus signal
2nd channel signal: DME external video bus signal
3rd channel signal: DME utility 1 bus signal
4th channel signal: DME utility 2 bus signal
Assigning to DME monitor outputs
1
Press the [M/E-1] button, turning it on.
2
Press the [KEY1] button, turning it on.
3
Press and hold the [MON] button and press the button
for a DME channel (DME1 to DME4) to assign.
Only DME channels assigned to the selected key can
be selected.
The output of the selected DME channel is assigned
to the monitor output (DME MON V and DME MON
K).
To check the status of the DME monitor output
You can check the status of the monitor output by the lit
color of the [DME1] button to [DME4] button while the
[MON] button is pressed.
Lit green: DME channel which is currently assigned to
the monitor output.
Lit amber: DME channel which can be assigned to the
monitor output.
135
Advertisement
Chapters
