Pc Displays An Error At Startup; Your Pc Doesn't Start Properly And Displays An Error Message On The Monitor; Memory Test Error - HP Vectra VL600 Supplementary Manual

Corporate pc
Hide thumbs Also See for Vectra VL600:
Table of Contents

Advertisement

PC Displays an Error at Startup

When your PC starts up it performs a Power-on Self Test (POST) to test your
hardware configuration for any problems. If a problem is detected during the
POST, an error is displayed on your PC's monitor. The following section
describes what to do if your PC displays one of these error messages.

Memory Test Error

Problem
Possible cause
Power-On-Self-Test (POST)
The PC's memory modules
displays a memory test
are not installed correctly.
error.
The PC's memory modules
are not working.
If the problem persists, run DiagTools to diagnose the problem. Refer to page 14.
More Advanced Troubleshooting
You may need to update
your PC's Basic Input
Output System (BIOS).
The system board is not
working.
If the problem persists, contact your authorized support provider
1 Troubleshooting Your PC
Troubleshooting Help Zone
To try and fix this...
1
Disconnect the power cord.
2
Remove the PC's cover. See page 47 (DT) or page
81 (MT).
3
Check the memory modules are correctly
installed, of the correct type and in the correct
sockets (refer to page 50).
4
Close the PC, reconnect the power cord and check
that the PC boots (starts).
1
Disconnect the power cord.
2
Remove the PC's cover. See page 47 (DT) or page
81 (MT).
3
Replace the memory modules by known working
memory modules from the same model of PC. See
page 50 (DT) or page 84 (MT) for more
information on memory modules.
4
Close the PC, reconnect the power cord and check
that the PC boots (starts).
Create a floppy to update your PC's BIOS. Refer to
page 41.
1
Disconnect the power cord.
2
Remove the PC's cover. See page 47 (DT) or page
81 (MT).
3
Replace the system board by a known working
board from the same model of PC. See page 70
(DT) or page 107 (MT).
4
Close the PC, reconnect the power cord and check
that the PC boots (starts).
5
If the PC works, contact your authorized support
provider for further troubleshooting information.
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vectra vli 8

Table of Contents