First, Turn On or Restart
Your PC
To Go to the HP
Summary Screen
To Go to the Setup
Program
4 Managing Your PC
HP Setup Program
HP Setup Program
Follow these instructions to check your PC's configuration when you
first use the PC:
If your PC is off, turn on the display and then the PC.
If the PC is already turned on, save your data, exit all programs and
restart your PC. For Windows NT 4.0, Windows 95, Windows 98 or
Windows 2000, u se the
command in the
Start
the operating system and restart the PC.
While the Vectra logo appears on your display, press
you to the HP Summary Screen. The Summary Screen will appear for
only a short time. To retain the screen indefinitely (until you decide to
leave it), press the
The Summary Screen shows the basic configuration of your PC, such as
the amount of main memory and the type of processor installed.
To go immediately into the Setup program while the Vectra logo
appears on your display (and bypass the Summary Screen), press
instead of
.
Esc
The Setup program allows you to view and change the configuration of
your PC, such as the passwords, standby (power saving) mode, IRQ
settings and boot device order.
124
ð
Shut Down
menu. This command will automatically exit
key.
PAUSE
Restart your computer
. This will take
Esc
F2