Installing Removable Media Devices - HP Vectra VL600 Supplementary Manual

NOTE
2 How to Install and Replace Components In Your Desktop PC
Upgrading and Installing Mass Storage Devices
7 Replace the cover (described in this chapter).
8 Verify the new configuration by checking the HP Summary Screen.
To access the HP Summary Screen, press
appears during startup.
Ensure that you have installed all the required operating system and HP
drivers on the newly installed drive. To reinstall operating system and
HP drivers, use the HP Image Creation & Recovery CD-ROM provided
with the PC. In addition, you can find the most up-to-date versions of
HP drivers on HP's Web site at:

Installing Removable Media Devices

The PC has an integrated Enhanced IDE controller which supports up
to four IDE devices. Removable media IDE devices, such as CD-ROM
drives, CD-RW drives, DVD drives, tape drives and Zip drives, require
front access. You can install a removable media IDE drive in an empty
front shelf.
Refer to the drive's manual to see if you must set jumpers or if there is
a special installation procedure to follow.
1 Remove the computer's cover (described in this chapter).
2 Press the two latches inward and slide out the drive tray.
filler plate
3 Remove the filler plate from the front of the tray.
58
when the Vectra logo
Esc
www.hp.com/go/vectrasupport.