Safety - AGFA Classic E.O.S. Installation Planning

Hide thumbs Also See for Classic E.O.S.:
Table of Contents

Advertisement

DD+DIS303.03E
1
Edition 6, Revision 0

Safety

General safety instructions
• The machine must only be used as described in the operating instructions.
Any other use may result in damage to the machine or may affect the
machine function with the consequence that the machine can no longer be
used as intended, and therefore presents a risk for patients, user, and
environment.
• The machine must only be operated by qualified personnel trained on the
machine.
• Ensure that only trained personnel have access to the machine.
• Ensure that the machine can always be supervised and that any tampering
is prevented.
• Repairs or modifications on the machine must only be performed by
trained service personnel authorized by Agfa.
• In case of visible damage on the machine housing the machine must not
be operated or used, and must immediately be disconnected from the
mains.
• Built-in or external safety devices must not be circumvented or disabled.
• Disconnect the machine from the mains before starting any maintenance.
• If a mains connection is absolutely required these maintenance routines
must only be made by specially trained personnel.
• Like all technical devices, this machine must be operated, cared for and
serviced correctly as described in the documentation provided with the
machine.
• If the machine is not operated correctly, or if it is not serviced correctly,
Agfa will not be liable for any resulting disturbances, damage or injuries.
• When installing the machine make sure that either the mains plug or an
all-cable disconnecting device is provided in the internal installation close
to the machine and is easily accessible.
• If the machine is connected with other components or assemblies, Agfa
will guarantee safety only for combinations which are approved by Agfa.
• In case of conspicuous smoke or noises, immediately disconnect the
machine from the mains.
Special instructions for the handling of chemicals
• When handling chemicals, always observe the applying safety and
environmental regulations, as well as the operating and warning
instructions pertaining to these chemicals.
• Wear stipulated protective clothing and safety goggles.
• When disposing of chemicals and waste water, you must comply with the
local regulations concerning waste water and environmental protection.
• If photo-chemicals get in your eyes, proceed exactly according to the
warning instructions and/or the instructions published by the
manufacturers of the chemicals. If required, immediately rinse your eyes
with cold water. Afterwards see the doctor immediately.
• Avoid inhaling of chemical fumes. Make sure that there is sufficient
ventilation at the installation site of the machine, i.e. an air exchange that
is at least ten times the room volume per hour.
• Always comply with the installation instructions.
• Verify tightness of all connections for chemicals and water, as well as
waste water, on the machine in regular intervals. At least check whenever
suggested in the operating instructions and/or service instructions.
Classic E.O.S. / Classic E.O.S. CL
(Type 5270 / 100 / 105)
Installation Planning
Chapter 14 / 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Classic e.o.s. cl5270/1005270/105

Table of Contents