Table of Contents
Advertisement
DD+DIS303.03E
8.3.1
Edition 6, Revision 0
Installing the disposal hoses
WAT
FIX2 FIX1
5270_10003_017.CDR
Pos Designation
1
PVC hose Ø 19x2.5 mm
(0.75x0.10 inch) transparent
2
Hose clamp
3
Hose connection stub
Ø 20 mm (0.79 inch)
5
Hose clamp
8
PVC hose,
Developer (red, fiber-reinforced):
Ø 19x4 mm (0.75x0.16 inch)
Fixer (blue, fiber-reinforced):
Ø 19x4 mm (0.75x0.16 inch)
Water (transparent, fiber-reinforced):
Ø 19x4 mm (0.75x0.16 inch)
• Shorten the internal disposal hoses if necessary and insert the hose
connection stub (3) again.
• Connect the fiber-reinforced (external) PVC hoses with the hose connection
stub (3) of the internal disposal hoses.
• Position the disposal hoses of developer (DEV) and fixer (FIX) together
through the opening in the bottom and to the central disposal site.
• Combine the hoses of the safety overflow (OVERFLOW) and water (WAT)
with a Y piece and connect them with one drain hose, if this is permitted by
the local regulations. Install the drain hose to the floor drain.
Classic E.O.S. / Classic E.O.S. CL
(Type 5270 / 100 / 105)
DEV
1
3
8
Figure 20
Installation Planning
2
5
Configuration
Pre-installed in the machine
Not included in the shipment,
CM+9037200400
Not included in shipment,
can be ordered
CM+0000064133
CM+0000064134
CM+0000007620
Chapter 14 / 21
Advertisement
Table of Contents
