Table of Contents
Advertisement
Assembly Instruction for Installing the control panel, side panels , hopper cover and grill.
Installing the Casings on K100.
Before installing the casings you should check
immediately whether the packing is complete
and in perfect condition, possible damages or
parts missing must be reported before pro-
ceeding with installation. Following procedure
describes how to install the casings for the
K100 unit.
Equipment required.
Philips Screwdriver, PH2
10mm open ended spanner.
Required parts
Place the display located inside the pellet hop-
per on the back of the unit, as shown in Figure
12. To perform this task, slightly unfasten the
screws located in the rear of the unit. When
securing the display it may be necessary to
adjust the height.
Note
When installing the display handle it with care
because there is a cable from the central unit
of the stove connected to it. Disconnecting this
cable will prevent the proper operation of the
equipment.
Fit the lower holes on the side covers (figure
13) to the guides located at the bottom of the
machine (Figure 14).
Fig. 13
Fig. 11
Fig. 12
c)
Next, attach the side casing by sliding it
downwards. During the assembly of the cas-
ing, make sure the flap on the top side (1) is
placed overlapping the structure and, simulta-
neously, covering the rear side of the unit on
the outside, as shown in Figure 15 & 16
Fig. 14
Advertisement
Table of Contents
