Using the Pellet Stove
Before starting up the unit, please check the
following:
Ensure the unit is properly connected to the
power mains using the 230V AC power cable.
Fig. 9
Check if the pellet reservoir is supplied with
pellets. Inside the pellet reservoir is a safety
grid to prevent users from reaching the worm
screw.
The combustion chamber of the stove and the
door are built in steel sheet painted with high
temperature paint, releasing fumes during the
first ignition due to the cure of the paint.
Avoid touching the equipment during the first
burn so as not to leave permanent marks on
the paint because it's going through a plastic
phase during its curing process.
Charging the pellet Wormscrew
Prior to the first use the wormscrew can be
primed to make the initial light up easier.
Press the " menu" button twice, followed by
repeated pressing of the "+" button until " set-
tings" is displayed.
Press "menu/ set" followed by repeated press-
ing of the "+" button until " charge pellet" is dis-
played.
Press "menu/ set" the wormscrew will rotate
continuously, continously monitor the crucible/
burnpot, when pellets begin to drop press"esc"
to stop the wormscrew.
The stove has a probe for measuring the room
temperature. This probe is attached to the grid
on the rear panel For a good reading of the
room temperature, avoid the contact between
the end of the probe and the unit surfaces. You
may also attach the probe to the wall beside
the unit.
Fig. 10
Remote Control
The infrared remote control allows the user to
turn the unit ON and OFF, control the fan air-
flow and increase or decrease the unit's power
level.
Fig. 11
Control and Display Panel
Fig. 12
Press to access
control panel
10