Table of Contents
Advertisement
Alarm
Code
Pellet drum
Er01
temperature is
too high
Pressure regu-
Er02
lator
alarm
Extinguishing
Er03
for
exhaust under
temperature
Extinguishing
Er05
for
exhaust over
temperature
Encoder fan
Er07
error: no
Encoder
signal
Encoder fan
Er08
error:
Combustion
Fan
regulation failed
Failed ignition
Er12
110 °C, even with
the
equipment OFF
Door open, draught
too
low or extractor fault
for
180 sec. Only visible
if
puller is set to ON.
Temperature below
55ºC (Th03)
Over 300 °C
No rpm signals.
Allows
unlocking and work-
ing
by voltage in a
provisional way
P25=0
Encoder has signal
but
failed regulation.
Can
be released and
working temporarily
by
voltage P25=0
Maximum time: 900
s
and exhaust
temperature below
50°C
Troubleshooting
- Room fan not working - call for
service
- Thermostat defective - call for
service
- Ventilation defective
- Close door and remove faulty
pressure switch
- Faulty exhaust pipe obstruction or
extractor
- Pellet reservoir is empty
- Faulty thermocouple
- Room fan does not work or is at a
low power level - increase level to
maximum (if problem persists call
for service)
- Insufficient extraction
- Excess pellets
- Faulty smoke sensor
- Check connection
- Check that the fan is not blocked
- After remedying the fault, you
must select operating mode P25=2
again
- Blockage of exhaust pipe or
defective extractor
- After remedying the fault, you
must select operating mode P25=2
again
- Empty auger channel - restarting
- Ignition resistance burnt out -
replace resistance
- Firing basket incorrectly placed
- Exhaust temperature did not
exceed the value set on activation
Advertisement
Table of Contents
