Table of Contents
Advertisement
Ashling
Boiler & Non Boiler
Solid Fuel Stove
INSTALLATION AND OPERATING INSTRUCTIONS
This appliance is hot while in operation and retains its heat for a long period of time after use.
Children, aged or infirm persons should be supervised at all times and should not be allowed
to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
When using the boiler stove in situations where children, aged and/or infirm persons are
present a fireguard must be used to prevent accidental contact with the stove. The fireguard
should be manufactured in accordance with BS 6539.
Advertisement
Table of Contents
Related Manuals for Stanley Ashling
Summary of Contents for Stanley Ashling
- Page 1 Ashling Boiler & Non Boiler Solid Fuel Stove INSTALLATION AND OPERATING INSTRUCTIONS This appliance is hot while in operation and retains its heat for a long period of time after use. Children, aged or infirm persons should be supervised at all times and should not be allowed to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
-
Page 2: Table Of Contents
TABLE OF CONTENTS PAGE NO. General ..............Handling . -
Page 3: General
ASHLING SOLID FUEL STOVE INSTALLATION & OPERATING INSTRUCTIONS The complete installation must be done in accor- NOTE: Please note that it is a legal requirement dance with current Standards and Local Codes. It under England & Wales Building Regulations that... -
Page 4: Flues
The effect of any screen should be allowed for when determining the effective The Ashling is a radiant room heater and must be free area of any vent. connected to a chimney of the proper size and type. -
Page 5: Permanent Air Vent
TOP FLUE EXIT Air vents traversing cavity walls should include a continuous duct across the cavity. The duct should Boiler Model be installed in such a manner as not to impair the weather resistance of the cavity. Joints between air For the top outlet configuration, connect bend (not vents and outside walls should be sealed to prevent supplied) into flue outlet socket at the rear of the... -
Page 6: Location
Fig.8 Fig.7 LOCATION There are several conditions to be considered in selecting a location for your Ashling Stove. a. Position in the area to be heated- central locations are usually best. b. Allowances for proper clearances to combustibles. -
Page 7: Technical Data
TECHNICAL DATA BOILER MODEL OUTPUT TO WATER OUTPUT TO ROOM TOTAL OUTPUT NOMINAL MAX. NOMINAL MAX. NOMINAL MAX. WOOD LOGS SOLID MINERAL FUEL 9.67 15.8 NON-BOILER MODEL OUTPUT TO ROOM TOTAL OUTPUT NOMINAL MAX. NOMINAL MAX. WOOD LOGS SOLID MINERAL FUEL Flue Outlet Diameter: 152mm Fire Door Size: 455 x 230... -
Page 8: Specification - Boiler Model
SPECIFICATION - Boiler Model Fig.9 SPECIFICATION - Non Boiler Model Fig.10 Note: Dimensions stated are in millimetres unless otherwise stated and may be subject to a slight +/- variation. -
Page 9: Plumbing - Boiler Model
a stable flow of water through both circuits and helps PLUMBING (BOILER MODEL) to prevent priority being given to the stronger flow, WARNING: DO NOT OBSTRUCT PRIMARY which is most commonly the pumped central heating AIR SUPPLY TO THE AIR DUCT AT THE BACK circuit. -
Page 10: Low/Slumber Burn
RECOMMENDED FUELS LOW / SLUMBER BURN To achieve an overnight or a low burn rate, close the The stove output levels are assessed on standard air wash slider fully by pulling out the air wash lever House Coals of good quality. Reduced outputs will using the ashpan lifting tool and turn the primary air result when fuels of lower calorific values are used. -
Page 11: Important Notes
IMPORTANT NOTES Now that your Stanley solid fuel Stove is installed and no doubt you are looking forward to many comforts it will provide, we would like to give you some tips on how to get the best results from your stove. -
Page 12: Lighting
Before lighting the stove check with the installer DE-ASHING that the installation work and commissioning checks described in the installation instructions When ash build-up becomes excessive in the fire have been carried out correctly and that the chamber shake the firebars by inserting the operat- chimney has been swept clean, is sound and free ing tool into the round slot on the right side of the from any obstructions. -
Page 13: To Clean Chimney Outlet - Boiler Model & Non Boiler Model
TO REPLACE DAMAGED GRATE OR GRATE TO CLEAN CHIMNEY OUTLET Boiler Model BOILER MODEL Remove baffle underneath the boiler cross flow Remove the two sets of side firebricks and the front chamber by lifting it upwards and pulling it outwards firebrick from the stove, taking care not to damage or and insert cleaning brush. -
Page 14: In Case Of Fire
2. For stubborn deposits a soap impregnated pad can be carefully used on the vitreous enamel. Waterford Stanley recommend the fitting of a CO Alarm in the same room as the appliance, this is a 3. Use only products recommended by the requirement under UK Building Regulations. - Page 15 ASHLING SOLID FUEL EXPLODED VIEW - NON BOILER MODEL - B00077BZZ 37. AIR CONTROL STAT KNOB - U00006AXX (BLK) - B00109AZZ U00124AXX (BR) FRONT DOOR - B00110BZZ 38. AIR WASH SLIDER CONTROL - F00717CXX DOOR GRILL - B00111BZZ 39. TENSION PIN...
- Page 16 ASHLING SOLID FUEL EXPLODED VIEW - BOILER MODEL Leg - B00077AZZ 36. Primary Air Control Stat Plate - F000221BXX Hob - B00109AZZ 37. Primary Air Control Stat Knob - U00006AXX Fire Door - B00110BZZ (BLK) U00124AXX (BRN) Door Grill - B00111BZZ 38.
-
Page 17: Installation Check List
INSTALLATION CHECK LIST Tick Flue System 1. Minimum Flue Height of 4.6 metres (15 feet). 2. Appliance should be connected to a minimum of 1.8 metres (6 feet) of 150mm (6”) flue pipe with a horizontal run not exceeding 150mm (6”). 3. - Page 18 NOTES...
- Page 19 NOTES...
- Page 20 Manufactured by Waterford Stanley Ltd., Unit 401-403, IDA Industrial Estate, Cork Road, Waterford, Ireland. Tel: (051) 302300 Fax (051) 302315 www.waterfordstanley.com www.stanleystoves.com Ref: N00068AXX Rev: 006 DP130903...