Installation & Operating Instructions; General; Pre Installation Assembly - Stanley Aoife Installation And Operating Instructions Manual

NOTE: Please note that it is a legal requirement
under England & Wales Building Regulations that
the installation of the stove is either carried out
under Local Authority Building Control approval or
is installed by a Competent Person registered with
a Government approved Competent Persons
Scheme. HETAS Ltd operate such a Scheme and
a listing of their Registered Competent Persons
can be found on their website at www.hetas.co.uk.

GENERAL

When installing, operating and maintaining your
Aoife Stove respect basic standards of fire safety.
Read these instructions carefully before commenc-
ing the installation. Failure to do so may result in
damage to persons or property. Consult your local
Municipal office and your insurance representative
to determine what regulations are in force. Save
these instructions for future reference.
Special care must be taken when installing the stove
such that the requirements of the Health & Safety at
Work Act are met.
Handling
Adequate facilities must be available for loading,
unloading and site handling.
Fire Cement
Some types of fire cement are caustic and should
not be allowed to come into contact with the skin. In
case of contact with the skin wash immediately with
plenty of water.
Asbestos
This stove contains no asbestos. If there is a possi-
bility of disturbing any asbestos in the course of
installation then please seek guidance and use
appropriate protective equipment.
Metal Parts
When installing or servicing this stove care should
be taken to avoid the possibility of personal injury.
IMPORTANT WARNING
This stove must not be installed into a chimney that
serves any other heating appliance. There must not
be an extractor fan fitted in the same room as the
stove as this can cause the stove to emit fumes into
the room.
AOIFE SOLID FUEL STOVE
INSTALLATION & OPERATING INSTRUCTIONS
The complete installation must be done in
accordance with current Standards and Local
Codes. Refer the installer to the current issues
of British Standards BS EN 15287-1:2007
design, installation and commissioning of
chimneys. BS EN 14336:2004: Heating Systems
in Buildings. Installation and commissioning of
water based heating systems. BS EN 12828:
2003; Heating Systems in Buildings. Design of
water based heating systems. BS EN 12831:
2003; Heating Systems in Buildings. Method for
calculation of the design heat load. As applica-
ble to the appliance.
Refer to the current issues of British Standards BS
EN 15287-1:2007 design, installation and commis-
sioning of chimneys. BS EN 14336:2004: Heating
Systems in Buildings. Installation and commission-
ing of water based heating systems. BS EN 12828:
2003; Heating Systems in Buildings. Design of water
based heating systems. BS EN 12831: 2003;
Heating Systems in Buildings. Method for calcula-
tion of the design heat load. As applicable to the
appliance.
PRE-INSTALLATION ASSEMBLY
1. After removing the stove from its packaging, open
the firedoor and remove all contents from the
ashpan.
2. Fit the firedoor handle by screwing into the fire
door axle.
3. Remove the stove from the pallet and position it
in the final installation position (See Location &
Clearance to Combustibles Section).
Your Aoife stove is supplied with the following items:
•
Black Spring Handle Assembly (see fig. 1)
•
Glove
•
Ashpan
•
Operating Tool
•
Installation and Operating Manual
• Legs
• Leg Fixing Bolts
• Spigot
• Spigot Fixing Bolts
• Allen Wrench
6
Fig. 1