General; Pre-Installation Assembly - Stanley Erin Installation And Operating Instructions Manual

GENERAL

When installing, operating and maintaining your
Erin Stove respect basic standards of fire safety.
Read these instructions carefully before commenc-
ing the installation. Failure to do so may result in
damage to persons and property. Consult your local
Municipal office and your insurance representative
to determine what regulations are in force. Save
these instructions for future reference.
The complete installation must be done in accor-
dance with current Standards and Local Codes. It
should be noted that the requirements and these
publications may be superseded during the life of
this manual.
PRE INSTALLATION ASSEMBLY
1. After removing the stove from its pack,
open the ashpit door and remove the
contents from the ashpan. Attach the short
timber handle to the ashpit door using the M8
x 70mm long round head screw and the
spring washer. (See Fig.1).
2. Open the fire door using the detachable han-
dle and remove the contents from the fire
box.
ERIN SOLID FUEL NON BOILER STOVE
INSTALLATION & OPERATING INSTRUCTIONS
Fig.1
Fig.2
3. Remove the hob and place to one side, tak
ing care not to damage the enamel finish.
4. Place the plastic packing on the ground at
the back of the stove and lay the stove on
its back on top of the packing. (See Fig.3).
5. Remove the wooden pallet by taking out the
two retaining screws from the base of the
stove.
Fig.3
6. Fit the ash tray to the base using the two 1/4"
x 1/2" long round head screws and two of the
3/8" washers provided. Fit the tool holder to
the base using the two 1/4" x 1 1/2" long
countersunk screws, and two of the 3/8"
washers provided.
Fig.4
7. Fit the secondary air control rod bracket to
the ashtray using the two 1/4" x 1/2" long
round head screws and the two lock washers
provided. Fit the connecting rod through the
control rod bracket with the notches facing
downwards and leave it hanging loose until
the stove is standing upright. See Fig 5.
3