Scanning
Loading Film
Inserting the Film Holder
Load the film into the film holder and carefully insert the film holder straight into the film holder slot of
the scanner. Once the film holder has been inserted past a certain point, it is automatically drawn into
the scanner.
1
(1) Hold the film
holder
horizontally with
the
facing upwards.
2
3
• If the film holder is facing the wrong direction or tilted, you will not be able to insert it.
• For more information on loading film, see "Chapter 5 Setting the Film in Position" in Getting Started.
When the film holder is inserted into the scanner, frames and buttons will appear in the FilmGet FS
4
thumbnail window.
5
Thumbnail Window
• When you insert the film holder, calibration is performed automatically and the message "Calibrating..." will be
displayed. This calibration is to teach the correct "white (reference color)" to the scanner in order to scan film
with more accurate colors.
• Although it takes about one minute to complete the calibration operation the first time that the operation is
performed after the scanner is turned on, subsequent calibration operations will be completed in about ten
seconds.
30
FilmGet FS User's Guide
mark
(2) Check that the [R] mark can be seen properly from
the right side.
Main Window
(3) Insert the end with the
mark into the film holder slot of
the scanner.