Ricoh P C311W User Manual page 80

4. Configuring the Machine Using the Control Panel
• On
The same printer driver you have installed in your computer can be used with any
machine other than the one originally used for installation, if the machine is of the same
model.
• Export to NFC
Specifies whether or not to synchronize the data you have configured using the control panel
and Web Image Monitor with the data stored in NFC.
You can read and write the data in NFC by using the application corresponding to the
machine.
Default: [On]
• Off
Does not synchronize the data you have configured using the control panel and Web
Image Monitor with the data stored in NFC.
• On
Synchronizes the data you have configured using the control panel and Web Image
Monitor with the data stored in NFC.
Auto Continue
Sets the printer to ignore an error with paper size or type and continue printing. The printing stops
temporarily when an error is detected, and restarts automatically after about ten seconds using the
settings made on the control panel. However, if the size of paper specified on the control panel
and that of the paper loaded in the paper tray or the paper size specified for the print job do not
match when printing restarts, it may cause a paper jam.
Default: [Off]
• Off
• On
Supplies Status
Displays information about consumables.
• Toner
Black, Magenta, Cyan, Yellow
• Other Supplies
Waste Toner Bottle, Fusing Unit, Transfer Roller, Int. Transfer Unit
Toner Near End
Specifies the low toner level notification timing.
Default: [Normal]
• Sooner
78