1. Setting Up the Machine 33 cm (13 inches) 20 cm (7.9 inches) 89.6 20 cm (7.9 inches) Power Source 120 - 127 V, 60 Hz, 11 A 220 - 240 V, 50/60 Hz, 6 A 10 cm (4.0 inches) 70 cm (27.6 inches) ECB001...
Page 4
ECC030 ECC031 ECC032 ECB025 ECB026 ECB027 ECB028 ECB029 ECB030 Language English German French ECB231 ECB031 ECB032 ECB205...
Page 5
Configure the network setting. Go to page 4 "2. Configuring the Network Setting".
2. Configuring the Network Setting Check How the Computer Is Connected Specify how to connect to your computer according to the communication environment of your system. Which method do you want to use (wireless or wired)? Wireless Wired Connect using a Connect using an Use a router (access point)? USB interface cable...
After scanning the following QR code with After scanning the following QR code with your your smart device, search for the "RICOH smart device, search for the "RICOH Smart Smart Device Connector" application and Device Connector" application and download it download it from the site that appears.
Page 8
Connecting to devices using the WPA2-PSK or Connecting to the devices using the Open Mix Mode WPA2/WPA authentication system or Shared Key authentication Enter the encryption key using the [ ] or [ ] key, and then Press the [ ] or [ ] key to select the encryption method, press the [OK] key.
10. After "Connecting..." appears, press the WPS button on the Easy Setup Using the WPS Button router (access point) within two minutes. ● Make sure the Ethernet cable is not connected to the machine. ● In Steps 10 to 12, configure each setting within two minutes.
Page 10
12. Execute WPS (PIN system) from the router (access point)’s Press the [ ] or [ ] key to select [Quit Setup], and then the web page. [OK] key. Network Wizard IPv4 Configuration IPv6 Configuration Quit Setup ECB240 Press the [Menu] key. 13.
Page 11
Connecting the Machine via USB or Ethernet DUE077 DUE078 ● For details about IPv4 or IPv6 settings manually, see User's Guide. ● When connecting the machine via USB, USB interface cable is necessary to set up. ECC037 ● When connecting the machine via the Ethernet, the Ethernet interface cable is necessary to set up.
3. Installing the Printer Driver Follow the instructions in the setup wizard. If you already completed the Wi-Fi setting, click [The machine's ● The following items are necessary to set up a wired IP address has been already configured.]. connection. ●...
Control Panel Sheet ECB201 1 [Wi-Fi Direct] key 7 [OK] key 2 [Stop/Start] key 8 NFC 3 [Job Reset] key 9 [Power] key 4 [Menu] key 10 [Back] key 5 Display 11 Alert Indicator 6 Scroll Keys 12 Data In Indicator For safe and correct use, please be sure to read the Safety Information before using the machine.
Page 15
Trademark Android is a trademark of Google LLC. IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license. Wi-Fi, Wi-Fi Direct, Wi-Fi Protected Setup, WPA, Wi-Fi Protected Access, WPA2, and Wi-Fi Protected Access 2 are registered trademarks of Wi-Fi Alliance.