Advertisement
Image Send Problems
Problem
?
I WANT TO CHANGE THE FORMAT
OR COMPRESSION OF A SCANNED
IMAGE
I DON'T KNOW HOW TO CHECK AN
ADDRESS WHEN SENDING AN
IMAGE
AFTER THE ROUTER WAS
REPLACED, I CAN'T USE SCAN TO
NETWORK FOLDER OR SCAN
TRANSMISSION DOES NOT TAKE PLACE
?
Check
Did you select the correct destination
(destination information)? Is the
correct information (e-mail address or
FTP server information) stored for
that destination?
Does the image file exceed the e-mail
attachment limit set in the setting
mode (administrator)?
Did the image file exceed the file
attachment size limit of your mail
server?
(When Scan to E-mail is used)
Has the folder on the destination
computer been set as a shared folder
so that files can be sent to it?
(When using Scan to Network Folder)
Is [IPsec Settings] enabled on the
machine?
(When using Scan to Network Folder)
Did you place an original that is
folded?
Check
Use the [Format] key.
Tap the [Address Review] key.
Has the machine's IP address been changed?
!
Solution
■ Make sure that the correct information is stored for the destination and that the
destination is correctly selected.
If delivery by e-mail (Scan to E-mail) is unsuccessful, an error message such as
"Undelivered Message" may be sent to the designated administrator's e-mail
address. This information may help you determine the cause of the problem.
■ Check with your administrator.
If your administrator has set a limit on the size of transmitted files, a file that
exceeds the limit cannot be transmitted.
■ Reduce the size of the file attachment (reduce the number of pages to scan) for
one e-mail transmission.
The size of the file can also be reduced by scanning using a lower resolution
setting. Ask your mail server administrator (or Internet service provider, etc.) what
the file size limit is for one e-mail transmission.
■ If the destination folder is not configured as a shared folder, select "Sharing" in
the folder properties.
If the folder was moved or otherwise changed, the "Sharing" setting may have
been canceled.
■ Check with your administrator.
When [IPsec Settings] is enabled in setting mode, it may not be possible to scan
to a shared folder in some computer environments.
⇒ "Settings (administrator)" → [System Settings] → [Security Settings]
→ [IPsec Settings]
■ Following the instructions in the display, unfold the original, place it in the
automatic document feeder again, and re-scan it.
If a folded original is placed in the automatic document feeder, an error will occur
and scanning will be canceled when the actual original size is detected during
scanning.
47
Page
52
52
53
Advertisement
