Advertisement
General Problems
THE DISPLAYED BYPASS TRAY PAPER SIZE IS
?
NOT CORRECT
Check
Do the bypass tray guides match the
width of the loaded paper?
THE ORIGINAL MISFEEDS (AUTOMATIC DOCUMENT
?
FEEDER)
Check
Is too much paper loaded into the
document feeder tray?
Is the original a long original?
Is the original on thin paper?
THE PAPER MISFEEDS
?
Check
Is a torn piece of paper remaining in
the machine?
Is too much paper loaded in the tray?
Are multiple sheets feeding at once?
Are you using paper that is not within
the specifications?
!
Solution
■ Set the bypass tray guides to the width of the paper.
When loading paper in the bypass tray, be sure to pull out the extension guide to
enable the paper size to be detected correctly.
!
Solution
■ Make sure that the stack of paper in the tray is not higher than the indicator line.
► Placing the original (page 5)
■ When using the automatic document feeder to scan a long original, set the scan
size to [Long Size].
(Note that long originals cannot be copied using the copy function.)
■ Use the document glass to scan the original.
If you need to use the automatic document feeder, use [Slow Scan Mode] in
[Others] to scan the original.
!
Solution
■ Follow the instructions in the touch panel to remove all paper.
■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
► Loading paper (page 6)
■ Fan the paper well before loading it.
■ Use SHARP-recommended paper.
Using paper that is for other models or special paper that is not supported may
result in misfeeds, creases, or smudges.
⇒ - "SUPPLIES" in Start Guide
For paper that is prohibited or not recommended, see User's Manual.
14
Advertisement
