Advertisement
General Problems
I DON'T KNOW HOW TO CHANGE THE PAPER SIZE
?
Check
Set the paper size used in each tray in
the tray settings.
THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN
?
Check
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
THE IMAGE IS SKEWED ON THE PAPER
?
Check
Is too much paper loaded into the
bypass tray?
Are the bypass tray guides adjusted
to the width of the paper?
Are the original guides adjusted to the
width of the paper?
LINES APPEAR IN THE SCANNED IMAGE
?
Check
Are the scanning areas of the
document glass or automatic
document feeder dirty?
!
Solution
■ The "Tray Settings" key can be found in the home screen.
Tap this key to display the tray settings screen.
Tap the tray whose paper size you want to change, select the paper type, and
then tap the [Size] tab. Select the paper size and tap the [OK] key.
If you loaded a special size of paper in the bypass tray, tap the [Direct Entry] key
after tapping the [Size] tab, enter the paper size manually, and tap the [Execute] key.
!
Solution
■ This may improve some states of paper curling.
► Loading paper (page 6)
!
Solution
■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
The maximum number of sheets varies depending on the paper type setting.
■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
■ Adjust the original guides to the width of the paper.
!
Solution
■ Clean the scanning areas of the document glass or automatic document feeder.
► Maintenance (page 8)
16
Advertisement
