Advertisement
General Problems
Check
Are the bypass tray guides adjusted
to the width of the paper?
Is the bypass tray extension guide
pulled out?
Is the bypass feed roller dirty?
Is A5 (5-1/2" x 8-1/2") size paper
loaded?
Is the paper size specified?
Did you add paper to the bypass tray?
Are you using punched paper?
Are you using label sheets that
cannot be used?
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
PAPER DOES NOT FEED FROM THE PAPER
?
TRAY
Check
Is the paper loaded correctly into the
paper tray?
Has the tray been prohibited in some
modes (copy, print, fax, image send,
document filing)?
!
Solution
■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
► Loading paper (page 6)
■ When loading large-size paper, pull out the extension guide.
► Loading paper (page 6)
■ Clean the surface of the bypass feed roller.
► Maintenance (page 8)
■ When loading A5 (5-1/2" x 8-1/2") size paper, place the paper in the horizontal
(A5R (5-1/2" x 8-1/2"R)) orientation. (Excluding tray 1 and the bypass tray)
■ If you are using a non-standard size, be sure to specify the paper size.
If the size of paper loaded into a tray was changed, be sure to check the paper
size setting.
⇒ "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ When adding paper, remove any paper remaining in the bypass tray, combine it
with the paper to be added, and reload as a single stack.
If paper is added without removing the remaining paper, a misfeed may occur.
■ When using punched paper, set the paper type to punched.
⇒ "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ Labels without a carrier sheet may stick to the transfer surface and cause a
misfeed.
■ This may improve some states of paper curling.
► Loading paper (page 6)
!
Solution
■ Set the guides to the size of the paper.
Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
► Loading paper (page 6)
■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the
checkboxes of each mode ([Feeding Approved Job]). Functions without a
checkmark cannot be used for printing using that tray.
⇒ "Settings" → [System Settings] → [Common Settings] → [Paper Settings]
→ [Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]
15
Advertisement
