Advertisement
General Problems
Check
Is the bypass feed roller dirty?
SMUDGES APPEAR ON PRINTED OUTPUT
?
Check
Are you using paper that is not within
the specifications?
Are you printing on pre-punched
paper?
Does a message appear indicating the
need for maintenance?
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
WHEN PRINTING ON THICK PAPER, THE PRINT
?
RESULT IS DIRTY FROM THE 2ND PAGE ON
Check
Has the paper type been set
correctly?
!
Solution
■ Clean the surface of the bypass feed roller.
► Maintenance (page 8)
!
Solution
■ Use SHARP-recommended paper.
Using paper that is for other models or special paper that is not supported may
result in misfeeds, creases, or smudges.
⇒ - "SUPPLIES" in Start Guide
■ Take care that the image does not overlap the punch holes.
If the printed image overlaps the punch holes, smudges may appear on the
reverse side of the paper following 1-sided printing, or on both sides following
2-sided printing.
■ Contact your dealer or nearest SHARP Service Department as soon as possible.
■ This may improve some states of paper curling.
► Loading paper (page 6)
!
Solution
■ Set the correct paper type in the tray settings. Make sure that the following did
not occur:
• When using heavy paper, change the paper type in the tray settings to Heavy.
(The image may disappear if rubbed.)
• Paper other than heavy paper is being used, but heavy paper is selected in the
tray settings. (This may cause creases and misfeeds.)
⇒ "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
17
Advertisement
