How To Display A Still Image From The File List; How To Save Motion Images - Furuno FSV-25S Operator's Manual

7. RECORD/RECALL OPERATION
7.3.2

How to display a still image from the file list

1. Right click the numeric/graphic data display to show the pop-up menu.
2. Click [Record/Recall].
3. Click [Still Image].
4. Select a file from the file list.
5. Select the play button (green triangle) on the window then push the left button to
recall the still image window. A maximum of eight windows can be shown on the
display.
6. Click [Quit] on the window to close the window.
7. Click [Quit] on the still image window to close the window.
7.4

How to Save Motion Images

The FSV-25/FSV-25S can store motion images as shown below.
1. Right click the numeric/graphic data display to show the pop-up menu.
2. Click [Record/Recall].
3. Click [Motion Image].
4. If two monitors are used, select where to save the image. 1, Main monitor, 2, Sub
monitor.
5. Click the button with a red circle to start the saving.
6. Click the button with a red circle to stop the saving. The file is saved to the location
specified in section 7.1. The file name is automatically saved in the following for-
mat:
yyyy_mm_dd_hh_mm_ss.avi
Note: When the size of the image is greater than 2GB, the image is saved in divi-
sions of 2GB. In this case the division no. appears after the "seconds" indication.
For example, yyyy_mm_dd_hh_mm_ss_1.av; yyyy_mm_dd_hh_mm_ss_2.avi.
7. Click [Quit] on the [Motion Image] menu to close the window.
Note: If the capacity at the destination is approaching maximum, the message "Disk
capacity is approaching maximum. Delete unnecessary data." appears. In this case,
select [Delete Data] then push the left button to delete unnecessary data.
7-4
Still Image
File Name Disk Info
File name list
Motion Image
File Name Disk Info
File name list
Quit
Monitor
1
Monitor list
Quit
Monitor
1
Monitor list