Komatsu H75051 Operation & Maintenance Manual page 292

TRANSPORTATION
1.
Start the engine.
2.
Set the machine horizontally and set the work equipment
in the travel posture.
See "METHOD FOR STARTING MACHINE (TRAVEL
FORWARD AND REVERSE, AND SHIFTING GEAR) AND
STOPPING MACHINE (3-182)".
(A): 30 cm
3.
Check that the multifunction mono-lever is in "HOLD" posi-
tion.
4.
Press the work equipment lock switch (1) and lock the
work equipment (the pilot lamp in the switch is lit).
5.
Stop the engine.
6.
Check the safety around the operator's seat, set the frame
lock bar to LOCK position (L) in order to prevent the front
frame and rear frame from being articulated.
7.
Use the lifting tools such as the wire rope and sling suita-
ble for the weight of the machine as shown in the figure of
the lifting position. Reeve the wire rope to the lifting posi-
tions of the machine.
NOTICE
• Use protectors, etc. so that the wire ropes will not
be broken at sharp edges or narrow places.
• Width of the threader and bar must be sufficient
for preventing the lifting equipment and wire rope
from contacting the machine.
• Remove the rear full-length fender before lifting a
machine if the machine is equipped with the rear
full-length fender.
8.
Just before lifting up the machine, set the slings, and lift the machine 100 to 200 mm off the ground first.
Check that the wire ropes are not slack and the machine is level, then lift it up slowly.
3-226
OPERATION