Furuno VR-7000S Installation Manual page 71

2.8.4 MC-3010A/3020D connections
Unfasten four screws to remove the cover, pass the cables through the clamps and
attach the cables to respective connectors. The shield part of the cable (or drain wire)
must be fastened by (connected to) the clamp. For fabrication of the cables connected
to the unit, see appendix 2.
• MC-3010A: Inputs analog signal. To set MC-3010A to the current input, connect
short pins to each terminals.
• MC-3020D: Inputs digital signal (8ch contact input). Contact or voltage input is se-
lectable (contact input requires short pins).
Note: Fasten the cable shield with the cable clamp.
Note: Fasten the cable shield with the cable clamp.
J5 J5
J4 J4
J3 J3
J2 J2
J1 J1
MC1.5-W-L cable MC1.5-W-L cable
MC-3010A
J6 J6
J4 J4
J5 J5
J2 J2
J3 J3
J1 J1
MPYC-12 MPYC-12
MC1.5-W-L MC1.5-W-L
MC-3020D
For TTYCSLA cables, pass the drain wire
through the shrink tube, then attach these crimp-
on lugs and screws to connect drain wires to here.
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
TTYCS-1/ TTYCS-1/
TTYCSLA-1 TTYCSLA-1
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
2. WIRING
2-31