Furuno VR-7000S Installation Manual page 15

• Adjust the cable length so that the cable routes verti-
cally to the float-free DRU and horizontally to the junc-
tion box. See the example figure to the right for
reference.
• As shown in the following figure, fasten the bracket and the junction box (VR-7022F)
to the steel plate, then fasten the steel plate to the ship's hull.
For details, see the outline drawing. If there is not enough space on the steel plate
to install the junction box there, install only the bracket on the steel plate. The rea-
son for installing the bracket on the steel plate is to prevent water from leaking into
the bracket from the rear of the bracket.
• The thickness of the steel plate should be 6 mm.
• Install the bracket on a flat steel plate flush with the steel plate.
• The bending radius for the cable that binds the capsule to the junction box should
be 80 mm or more.
• Pass the ground from the bracket through the steel plate and connect it to the
ship's hull.
• The cable gland on the junction box can be horizontal or vertical.
500mm
200mm
Recommended mounting method.
300mm
To be fastened
to the hull
Cable gland
(Horizontal)
Mounting method when there is not enough space on
the steel plate to install the junction box there.
To be fastened
to the hull
Cable gland
R80mm
(Vertical)
1. MOUNTING
90°
90°
300mm
R80mm
1-7