Microphone Vr-7011 - Furuno VR-7000S Installation Manual

2. WIRING
2.5

Microphone VR-7011

Connect wiring to the terminal board of the unit, referring to the interconnection dia-
gram at the back of this manual. See appendix 2 for how to fabricate the cable.
Microphone (back cover removed)
After fabricating the cable, connect it to the connector J1.
After wiring the cable, reattach the back cover to the unit. Then fix the cable to the ca-
ble clamp with the cable tie (supplied).
2-16
Connector J1
Pin No. Signal
1 12 VDC
2 GND
3 MIC_AUDIO
4 MICTEST
Fix the cable to this cable clamp.
In/Out
In
-
Out
In