Furuno VR-7000S Installation Manual page 32

1. MOUNTING
8. After wiring, tighten the nut according to the information in the table below.
9. Fasten the front panel to the waterproof cover with the four binding screws re-
moved at step 1.
Note 1: Before fixing the front panel, make sure the waterproofing gasket is cor-
rectly seated in the groove in the waterproof cover.
Note 2: Take care not to bend or pinch the cable.
When the cable entrance is the super gland
1. Remove four binding screws to detach the front panel from the waterproof
cover.
2. Fasten the waterproof cover to the mounting location with four self-tapping screws
(supplied).
3. Remove the nut from the super gland.
1-24
Clamp location
Cable jacket
Sheath
Front panel Front panel
Waterproof Waterproof
cover cover
Clearance
Clearance Torque
2.0 mm 2.0 - 2.5 Nm
1.5 mm 2.0 - 2.5 Nm
Binding screw Binding screw
(4 pcs) (4 pcs)
Self-tapping screw Self-tapping screw
(4 pcs) (4 pcs)
Super gland Super gland