Furuno VR-7000S Installation Manual page 21

How to attach the cover
Attach the cover to the bracket as follows. If the cover is not attached correctly, the
cover and capsule may drop out of the bracket due to wind and/or vibration.
1. Fit the notch on the cover with the ridge on the bracket.
2. There is a groove alongside the cover that has to be aligned and fit around the
tongue on the bracket. Align the tongue on the bracket and groove alongside the
cover.
Align this groove to the Align this groove to the
tongue on the bracket. tongue on the bracket.
3. Attach the cap to the hole at the top of the cover, then insert the safety clip.
Note: Make sure the safety clip is mounted correctly, referring to the following fig-
ure.
Notch Notch
Ridge Ridge
Safety clip Safety clip
Cap
Fit the notch with Fit the notch with
the ridge. the ridge.
1. MOUNTING
1-13