Waterproof Microphone Vr-7012W - Furuno VR-7000S Installation Manual

2.6

Waterproof Microphone VR-7012W

Connect wiring to the terminal board of the unit, referring to the interconnection dia-
gram at the back of this manual. See section 1.6 for how to fabricate the cable.
Front panel of the waterproof microphone (rear side)
After fabricating the cable, connect it to the connector J1.
After wiring the cable, reattach the front panel to the waterproof cover. Then fasten the
super gland or SC lock to fix the cable.
Connector J1
Pin No. Signal
1 12 VDC
2 GND
3 MIC_AUDIO
4 MICTEST
Fasten the cable gland or cable lock.
2. WIRING
In/Out
In
-
Out
In
2-17