Left Original Beeper; Copy Face Up; Job Preset - Gestetner CS555 Copy Reference Manual

Left Original Beeper

The beeper sounds and an error mes-
sage is displayed if you leave origi-
nals on the exposure glass after
copying.
Note
❒ See p.143 "Tone: Original Re-
mains".

Copy Face Up

Use this function to reverse the order
of copies.
Preparation
Before using this function, register
"Face up" as a copy function key.
See p.143 "Copy Function Key: F1-
F5".
A A A A
Press { { { { Face Up} } } } key.
B B B B
Place originals, and then press the
{ { { { Start} } } } key.

Job Preset

You can make settings for the next
copy job while copying is in progress.
If a long copy job is in progress and
you do not want to wait for it to finish,
you can use this function to make set-
tings for the next copy job in advance.
When the current copy job finishes,
the next job begins automatically.
Reference
See "Job List", General Settings
Guide.
A A A A
Press [New Job] when "
" is displayed.
ing...
B B B B
Make settings for the next copy
job.
C C C C
Place the originals in the ADF,
and then press the { { { { Start} } } } key.
All originals are scanned.
After the current copy job, the next
job starts automatically.
Note
❒ Each job stored is allocated a job
number that is displayed on the
Reserved Job screen.
❒ To switch the display to the cur-
rent copy job press [Reserved
Job], followed by [Printing], and
then [Exit].
Basic Procedure
2
Copy-
21