Table of Contents
Advertisement
DolphinC2_ENcopy_F_FM.book Page 8 Friday, February 25, 2005 10:46 AM
Basics
Copy output
Copy Output:
Front
1
Copy Output:
Rear
Important
❒ The paper capacity indicated assumes the use of standard copier paper, and
should only be used as a guide. If the paper exceeds the upper limit, the cop-
ies may become folded or cause paper jams.
Original Output Locations
The following original output loca-
tions are available:
❖ ❖ ❖ ❖ Top Original Exit
This is the basic original output lo-
cation. Originals are ejected onto
the upper output stacker.
❖ ❖ ❖ ❖ Rear Original Exit (straight)
Originals are ejected onto the orig-
inal output supports. When copy-
ing thick or hard originals, select
this output location.
8
Capacities
Roll paper
Plain paper (at normal tem-
perature and humidity):
Plain paper (at high or low
temperature and humidity):
Translucent paper(vellum):
Film:
Cut sheet paper Plain paper, and translucent
paper (vellum):
Film:
• Same size copy paper
• Normal temperature = 23°C
Normal humidity = 65%
A1 (D)K, A0 (E):
• Same size copy paper
• When using A0 size copy paper, attach the copy output (rear) auxiliary
guide. See p.11 "Using the rear output to eject A0 (E) KPaper".
99 sheets
10 sheets (A1L to A2)
99 sheets (smaller than A2)
10 sheets
1 sheet
10 sheets
1 sheet
10 sheets (plain paper)
1 sheet (translucent paper)
1 sheet (film)
❖ ❖ ❖ ❖ Rear Original Exit (document roller)
When copying rolled originals
such as long length originals, select
this output location so that origi-
nals can be rolled and stacked by
the document roller. See p.9 "Rear
Original Exit (Document Roller)".
Note
❒ Originals of 52.3 g/m
2
g/m
(13.9 lb – 27.9 lb) can be
used with the document roller.
❒ Do not use the document roller
when copying originals that are
l o n g e r t h a n t h e m a x i m u m
length for each paper type. Use
both hands to roll the original.
2
– 104.7
Advertisement
Table of Contents
