Shindaiwa DGK45F Owner's And Operator's Manual page 45

< Note >
 When removing the fuel hoses, hold the union joint fixed using a spanner or similar tool.
 Prepare a container to receive the fuel remaining in the fuel piping that will flow out of the
removed fuel piping.
Lift the generator, separate the spill containment and set the generator on a flat surface.
5
After cleaning and inspecting the inside of the spill containment, reassemble the spill
6
container with this generator by performing the above procedures in the reverse order.
Reassemble the fuel piping and wiring connector to their original positions.
7
Turn the 3way fuel valve lever to the "B" side.
8
< Note >
 After reassembling, bleed air from the fuel system.
(Refer to section "9-3. Procedures during Operation".)
 After reassembling, check that there is no fuel leakage.
 Spill Containment Cleaning/Inspection
Use a high-pressure cleaner or similar equipment to clean the inside of the spill
1
containment.
After cleaning, allow water to accumulate and check that the spill containment has no
2
internal leakage.
Remove the drain plug (R1") to drain the cleaning water.
3
Check that there no rust has developed inside of the spill containment. If rust has
4
developed, remove the rust and clean again.
After the procedures have been completed, apply sealant coating to the plug (R1") or
5
wrap it in seal tape.
< Note >
 If the fluid drained when cleaning the spill containment
contains oil or grease, dispose of it according to the related
laws and regulations.
 If the spill containment has a leak, contact the authorized
distributor where the generator was purchased.
Position A
42
Position B
Drain Plug (R1")