< Note >
Check that the surrounding area is safe before starting the engine.
When there are multiple workers who are working together, they must mutually signal each other
before starting the engine.
Do not use in an area with high temperature or humidity, or an area with a large amount of dust.
Do not open any doors during operation. Operating with door open can negatively affect cooling
effect, resulting in an equipment malfunction.
Use ear protection if the level of noise is high. Failure to do so could result in hearing damage.
Please be careful about a strong wind and the opening and shutting of the door at the sloping
place enough. A door is open suddenly and is closed, and a finger might be sandwiched.
Turn the three-phase and single-phase breakers on the operation panel to OFF.
1
Turn the Throttle switch to IDLING.
2
Turn the Starter switch to RUN/PREHEAT.
3
When the pre-heating indicator changes from lit up to off, immediately change the
4
switch to START and start the engine.
< Note >
Pre-heating time depends on the coolant
temperature, and completes in
approximately 0.5 to 8 sec.
Do not continuously operate the starter
motor for 10 sec. or more.
If repeating starter switch operation, wait
60 sec. or more between re-starting.
Be aware that smoke might be
generated when the engine is started.
5
After starting the engine, remove
your hand from the starter switch.
6
Let engine idles for approximately for five minutes.
7
Turn the Throttle switch to RUN.
Adjust the voltage regulator dial to the specified voltage.
8
Turn the breakers to ON to start AC power delivery.
9
9-2. 240/480 V Switching Selection
WARNING : ELECTRIC SHOCK
If performing any electric voltage switching, turn all breakers to OFF and stop
operation.
Lock the generator using a padlock so that no one except for designated
operators can operate switches.
Starter
Throttle
Pre-Heating
Indicator
Switch
Switch
29
3-Phase
1-Phase
Breaker
Breaker
Voltage
Regulator